最新コーティング方案を発信するShimada Appli(シマダアプリ)→High T.E. spray

塗分け可能なマイクロスプレー、セレクトスプレーで3Dデバイス等へ均一薄膜形成。

New conformal coating system that does not spinnability(angel hair) by FSCC06 Selective Spray Coater

2020-11-05 | 特許製品

FS micro spray gun utilizing atomization system with solvent mist fog, spray coating technology that does not spinnability with even high viscosity material. We developed a technology that can spray paint and adhesive etc. without spinnability(angel hairs). We have already applied for overseas patents and have already been put to practical use for painting, and we will proceed to develop conformal coatings such as moisture proof and insulation on the mounting board in the future. When applying Elepcoat (model LSS 540 MHF) manufactured by Nitto Shinko Corp. which is a solvent-containing moisture proof insulating material, angel hair occurs unless weight ratio is 1: 1 in order to counteract angel hair with air spray or airless spray. (External division 100% weight ratio dilution) By using this spray coating device, the following good results were born. Coating application results Coating material: Conformal coating material Elepcoat type model LSS 520 MHF (manufactured by Nitto Shinko Co., Ltd.) Undiluted solution 400CPS Solids content 15-35%   As the solvent to be contained, methyl cyclohexane, mineral spirit Solvent used for making solvent mist: mineral spirit The amount of solvent used that does not cause angel hair and the results of application under each condition are shown below. The amount of mineral spirits generated by solvent mist preparation when 6.89 CC of the above stock solution was applied, With 1.5 CC (diluted 22%), it was possible to apply without problems. Automatic spray gun: Model FSCC 06 Selective spray coater low ejection volume micro spray gun used.          Atomizing air pressure: 0.1 Mpas (Best condition: 0.08) (6 NL / min at air flow rate value) Liquid pressure: 200 Kpas Coating speed: 250 mm / s standard (area coat: scanning speed of robot operation) Nozzle height: 15 mm (distance from the coated surface to the nozzle tip) Application result: No thread trimming, no shooting. With film formation with a dry film thickness of 25 μm, Touch drying time at that time: Within 3 minutes at ambient temperature @ 25 ° C 32% No stickiness with no wind. Cool air (with wind at room temperature 2 to 2.4 mm / s applied to coated surface) Within 1 min Warming (Place the substrate coated on a hot plate of @ 50 ℃.) Within 1 minute When forming a film with a film thickness of 30 μm Normal temperature 3.5 minutes @ 25 ° C 32% No stickiness in no wind. Blowing (wind speed of 2 to 2.4 mm / s was applied to the coated surface with room temperature wind) within 1 minute Warming (Place the substrate coated on a hot plate of @ 50 ℃.) Within 1 minute.

New conformal coating system that does not spinnability(angel hair) by FSCC06 Selective Spray Coater


Comment    この記事についてブログを書く
  • Twitterでシェアする
  • Facebookでシェアする
  • はてなブックマークに追加する
  • LINEでシェアする
« 11月開催の川口市市産品フェ... | TOP | nano tech2021明日よりビック... »

post a comment

ブログ作成者から承認されるまでコメントは反映されません。