2016年9月16日 星期五

[製作章] 1/700 重巡洋艦 摩耶 MAYA (Part 3)



[製作章] 1/700 重巡洋艦 摩耶 MAYA (Part 3)

三連裝機銃全部安裝完成。而為了增加真實感,
用了銅線繞成繩索並放置於艦橋及機槍平台。在現實中,其用途是防止炮彈碎片擊傷水兵。
All triple-mount machine guns have been installed. In addition, copper wire was used to make 'rope' and put on Maya's bridge and anti-air machine gun platforms. This rope is to minimize the sailors' injury caused by any bomb fragment.


 重巡摩耶已大概已完成80%,希望於未來一個月可把她完成吧。
Heavy cruiser Maya is expected to be finished in the coming month.

2016年8月26日 星期五

[製作章] 1/700 重巡洋艦 摩耶 MAYA (Part 2)


[製作章] 1/700 重巡洋艦 摩耶 MAYA (Part 2)
前檣完成
The front mast is completed

後檣也完成了外形,尚欠爬梯及航海燈。
今天亦完成了置於飛行作業甲板前的士官用內火艇。
使用了Rainbow model的產品。
The aft-mast is still in making. Apart from that, the cutters have been finished. They are the product of Rainbow Model.

還有零式水上偵察機。
And the Type Zero reconnaissance seaplane.
但機翼也太厚了吧...可能重新做一架。
It seems that the wings are a bit too thick. May need to re-make one.

2016年8月23日 星期二

[製作章] 1/700 重巡洋艦 摩耶 MAYA (Part 1)

[製作章] 1/700 重巡洋艦 摩耶 MAYA

日本重巡摩耶為高雄級4號艦,昭和7年(1932年)就役。

於昭和18年(1943年)進行近代化改裝,撤去第3號主炮,增設2座八九式高射炮及大量對空機槍。加上外形壯觀尤如堡壘般的艦橋,被譽為「洋上對空要塞」。
 
可惜於昭和19年(1944年)出發參與'捷一号作戰'時,對空火力並未有機會發揮之前已美軍潛艇擊沉。
 
此作品將重現重巡摩耶於昭和19年被擊沉前的英姿。

Japanese Heavy Cruiser MAYA was one of the four Takao-class heavy cruisers which was commissioned in 1932.

In 1943, MAYA underwent a configuration and her No.3 turret was removed, and replaced by 2 type 89 127mm anti-air guns. Because of its enormous super-structure and the number of anti-air guns, MAYA was known as the anti-air fortress on sea among the Japanese Navy. 

However in 1944, before she could show the world her anti-air ability, MAYA was sunk by a US-Navy submarine in Palawan  Passage. 
 
使用了Flyhawk Fujimi 套改。需要作出一些修改打磨,
因為套改是配Aoshima的。

Flyhawk and Fujimi photo etched set for MAYA are used. As the Flyhawk set is designed for Aoshima's kit, certain polishing processes are required. 


 
前檣是最辛苦的部分,
用上了Flyhawk的PE加上自己裁剪的0.3mm銅棒。
13號電探的PE相信經常令人苦不堪言,小弟的建議是不斷練習。記得當年有一張PE共16個13號電探,結果只有5個成功...

The making of the front mast is probably the most difficult part because it is a combination of Flyhawk's photo etched part and a few 0.3mm brass rods.
And the making of type 13 radar is also a pain in the ass. To make a decent looking one, there is no fast route but practice.

[完成章] 1/350 戦艦 大和 YAMATO

[完成] 1/350 戦艦 大和 YAMATO


「建艦圖志」成立後第一篇Blog文,為大家送上1/350日本戰艦大和。
此作品的設定為昭和20年(即1945年)4月,
戰艦大和即將出發前往沖繩執行'天一号作戰'的時刻。

As the first post of this blog, I am introducing my latest finished work: 
1/350 Japanese Battleship YAMATO. 
The setting of this work is the final state of the battleship when she was about to carry out the 'Ten-ichi-gō' operation in April, 1945.




左舷對空炮群
Anti-air turrets on Port-side

左舷對空炮群
Anti-air turrets on Port-side

飛行作業甲板,零式三座水上偵察機 
Flight deck and the  Type Zero Reconnaissance seaplane

 46cm口徑主炮
46cm main turrets 
 
46cm口徑主炮 
46cm main turrets